Toyota Denso Yaris GR Turbo

• Air control: Efficiency in additional mode, Maximal mass air flow
• Boost control: limitation: Boost correction factor, Maximal boost pressure absolute, Torque clamp boost limiter, Boost limitation absolute, Boost limitation by torque, Boost limitation relative, Maximal boost relative
• Boost control: wastegate: Target wastegate duty, Wastegate duty in additional speed
• Camshaft Control: Intake Camshaft, Intake camshaft correction, Intake camshaft correction factor
• Engine speed limit: Engine speed limitation
• Fuel Pressure: Target fuel pressure, Maximum fuel pressure
• Fuelling Direct Injection: Injection I angle in additional mode, Injection II angle in additional mode
• Ignition Optimum: Spark advance optimal
• Sensors scaling: Mass air flow sensor scaling
• Spark advance: Ignition efficiency, Minimal spark advance, Spark advance in additional mode, Spark advance main, Spark advance retardation on camshaft, Spark advance warmup correction
• Throttle control: Primary throttle efficiency in additional gear, Primary throttle efficiency 1 [Normal mode], Primary throttle efficiency 1 [Sport mode], Primary throttle efficiency 2 [Normal mode], Primary throttle efficiency 2 [Sport mode], Primary throttle efficiency base, Primary throttle efficiency [gear 2], Throttle efficiency idle, Throttle position base
• Throttle: direct control: Throttle control limit in additional gear [Normal], Throttle control limit in additional gear [Sport], Throttle direct control limit [1st GEAR], Throttle direct control limit [1st GEAR] AWD High, Throttle direct control limit [1st GEAR] AWD Low, Throttle direct control limit [Reverse GEAR], Throttle direct control limit
• Torque model: Calculated torque from load, Engine speed by throttle position, Maximal engine torque, Torque Limiter, Torque limiter by temperature, Maximal torque
• Vehicle speed limit: Vehicle speed limiter (если найден)

• Air Control: Air mass flow sensor slope, Maximum MAP sensor
• Deactivation: Deaclivation turbo charger protection
• Engine Torque: Limiter of maximum torque, Torque request during take off condition in additional mode, Maximum Boost Limiter of Turbo Pressure
• Injection Warm Up: Injection warm up in additional mode
• Rail Pressure: Rail Pressure in additional mode
• Torque model: Limiter of Maximum torque, Optimal engine torque
• Spark Advance: Minimum Spark Advance, Spark Advance, Spark Advance base , Spark Advance correction , Spark Correction Water temperature

Драйвер usb-ключа 

Программа BitEdit 

По вопросам технической поддержки: 

• E-mail: support@bitbox.ru
• Skype: Bitbox.ru

Инструкция по активации модулей BitEdit:

1. Установите драйвер usb-ключа и программу BitEdit.
2. Вставьте ключ в ПК, запустите программу Bitedit.
3. Сообщите нам серийный номер вашего ключа (Dongle ID) с указанием номера вашего заказа на info@ecupro.ru
4. После получения от нас уведомления об активации, запустите программу BitEdit на ПК с подключенным интернетом.

Отзывы